Product Information
| | Boat Lift 7000lb. Kit Includes: |
4000lb Gear Unit (7000 lb compounded) Capacity Max, 1 HP TENV (Totally Enclosed Motor), 110 Volt (220 Volt Optional) and In-line GFCI, Lock on Switch, 14' Electrical Wire Motor to Switch(1) Dual pipe supports 24" between collars (2) Bearing Brackets with 4 bolts, nuts (4) 4" Upper Pulleys, Hanger Plates, & Shackles Aluminum Sheave w/Bronze 5/8 Bushing on 5/8 Shaft 3/8 in. thick x 2 1/2 in. x 12 in. Galvanized Hanger Plates. (4) Compound Pulley Tie Off Bracket W/Shackle (4) 4"Lower Block Pulleys W/Shackle & Grease fitting Aluminum Sheave w/Bronze 5/8 Bushing on 5/8 Stainless Steel Shaft (4) 6" X 9' , 9'6", 10', or 11' Hot Dipped Galvanized Steel I Beam (2) Chock Brackets 16" with Bolts, Nuts (8) 1/4" Galvanized Cable 75' each piece (2) (This will give 15' from upper pulleys down to all four corners to the cradles with a 10' wide boat slip)(Call us if additional amount of cable is needed) 1/4 in. Galvanized Drop Forged Cable Clamps (12) 1/4" Thimbles (4) Galvanized Shackles (8)
(2 in. ID Schedule 40 Pipe Not Included *Purchase Locally*) |
This kit works for a wide variety of boats. All hardware hot dip galvanized. Drive Pipe 2" ID Schedule 40 or 80 (not supplied). Timbers not included. Due to the variety of material thickness used in boat house construction, the bolts etc. are not supplied to connect the kit hardware to the boat house. These can be purchased locally to ensure the correct sizes.
Optional Remote Control - ORDER A TEC 1 REMOTE CONTROL WITH YOUR KIT FOR A SPECIAL PRICE! Comes with hand held remote and pre-wired ready to plug in. Remote operates as a momentary switch, must hold pressure on the up or down button to run the motor. Just click the drop down below to add to the kit!
Motors are TENV Totally Enclosed Non Vented. They are not sealed motors and must be protected from rain and weather.
1 Year Electrical Warranty
FREE SHIPPING ON THIS ITEM (SHIPS BY FREIGHT LINE SIGNATURE REQUIRED)
Cradle must be 1 ft. longer (minimum) than width of boat: Boat slip needs to be about 1' wider than cradle being used.
Example 8' wide boat then min. 9' cradle & slip 10'wide. 8'6"boat cradle min. 9'6" & slip 10'6" wide.
4 in. Block Pulleys in Lieu of 3 in. In-line GFCI in Lieu of In-Plug GFCI Galvanized Steel Flat Gear Plate. The Gears Are Manufactured in the U.S.A With the Best of Materials. 1 Year Electrical Warranty 6 Year Gear Plate Warranty
|
FREE SHIPPING ON THIS ITEM
